CVE-2026-93275: perf/x86/intel/pt: Fix stop/start with no update

In the Linux kernel, the following vulnerability has been resolved: perf/x86/intel/pt: Fix stop/start with no update If pt_event_stop() is called without PERF_EF_UPDATE flag, then perf_aux_output_end() is not called. A subsequent call to pt_event_start() will call perf_aux_output_begin() again which violates the rule against nesting and triggers a WARNING in perf_aux_output_begin(). Originally, pt_event_stop() was never called without PERF_EF_UPDATE, because the only code paths to do so are from event overflow, and Intel PT does not do that. However the introduction of group throttling by commit 9734e25fbf5ae ("perf: Fix the throttle logic for a group") meant that an Intel PT event could be throttled if it was part of a group. Throttling calls PMU ->stop() / ->start() callbacks without flags. An example is when AUX area sampling is used. The following commands hit the issue: echo 10000 > /proc/sys/kernel/perf_event_max_sample_rate perf record -F32000 --aux-sample -e '{intel_pt//u,cycles:u}' \ -- bash -c 'for i in `seq 1 100000` ; do true ; done' Use PERF_HES_UPTODATE to track whether perf_aux_output_begin() and perf_aux_output_end() are balanced. A cleared PERF_HES_UPTODATE bit indicates that an AUX output context is still open. Amend pt_event_start() / pt_event_stop() accordingly so that begin/end stay balanced: - In non-snapshot mode, stop() always closes the buffer (the buffer may have run out of space, and that accounting is done by the update), so a following start() opens a fresh one as before. - In snapshot/overwrite mode, stop() without PERF_EF_UPDATE leaves the buffer open so that pt_event_snapshot_aux() can still copy from it, and start() then only re-enables tracing instead of calling perf_aux_output_begin() again. Note that pt_event_del() calls pt_event_stop() with PERF_EF_UPDATE flag set (as is required by the documentation), so a final call to perf_aux_output_end() is assured.